Translations:Draft Pattern/3/en: Difference between revisions
(Importing a new version from external source) |
(Importing a new version from external source) |
||
Line 7: | Line 7: | ||
# Select a {{PropertyView|Pattern}}. |
# Select a {{PropertyView|Pattern}}. |
||
# Optionally change the {{PropertyView|Pattern Size}}. Note that a higher value results in a denser pattern. |
# Optionally change the {{PropertyView|Pattern Size}}. Note that a higher value results in a denser pattern. |
||
# The |
# The pattern is not displayed when the objects are selected. Deselect them to check the result. |
||
# Optionally reselect the objects to change the pattern properties. |
# Optionally reselect the objects to change the pattern properties. |
Latest revision as of 09:55, 27 September 2021
- Make sure the objects are closed and planar, and do not self-intersect.
- To close a Draft Wire, a Draft BSpline, a Draft CubicBezCurve or a Draft BezCurve set its DataClosed property to
true
. - To close a Draft Circle or a Draft Ellipse set its DataFirst Angle and DataLast Angle properties to the same value.
- Select the objects.
- Switch to the View tab of the Property editor.
- The ViewDisplay Mode must be set to
Flat Lines
. - Select a ViewPattern.
- Optionally change the ViewPattern Size. Note that a higher value results in a denser pattern.
- The pattern is not displayed when the objects are selected. Deselect them to check the result.
- Optionally reselect the objects to change the pattern properties.