Part Ellipse/ro: Difference between revisions

From FreeCAD Documentation
(Created page with "== Descriere == Un element primitiv geometric este Elipsa care este disponibil din dialogul Create Primitives în Atelierul de lucru Part.")
(Created page with "Dialogul Create Primitives pote fi accesat via iconiței CreatePrimitives 32px localizată în meniul Part sau P...")
Line 5: Line 5:
Un element primitiv geometric este Elipsa care este disponibil din dialogul Create Primitives în Atelierul de lucru Part.
Un element primitiv geometric este Elipsa care este disponibil din dialogul Create Primitives în Atelierul de lucru Part.


The Create Primitives dialogue can be accessed via the [[Part_CreatePrimitives|CreatePrimitives]] icon [[Image:Part_CreatePrimitives.png|32px]] located in the Part menu or the Part toolbar, in the Part Workbench.
Dialogul Create Primitives pote fi accesat via iconiței [[Part_CreatePrimitives|CreatePrimitives]] [[Image:Part_CreatePrimitives.png|32px]] localizată în meniul Part sau Part toolbar, în Atelierul Part(Workbench).


This command will create a elliptical curved edge. With the default values, the elliptical curved edge will be closed and therefore will be an ellipse. If the properties Angle 1 or Angle 2 are changed from their default values (0 and 360) the edge will be an open curve.
This command will create a elliptical curved edge. With the default values, the elliptical curved edge will be closed and therefore will be an ellipse. If the properties Angle 1 or Angle 2 are changed from their default values (0 and 360) the edge will be an open curve.

Revision as of 17:43, 27 October 2018

Part Ellipse

Menu location
Part → Create Primitives → Ellipse
Workbenches
Part, OpenSCAD
Default shortcut
None
Introduced in version
-
See also
..

Descriere

Un element primitiv geometric este Elipsa care este disponibil din dialogul Create Primitives în Atelierul de lucru Part.

Dialogul Create Primitives pote fi accesat via iconiței CreatePrimitives localizată în meniul Part sau Part toolbar, în Atelierul Part(Workbench).

This command will create a elliptical curved edge. With the default values, the elliptical curved edge will be closed and therefore will be an ellipse. If the properties Angle 1 or Angle 2 are changed from their default values (0 and 360) the edge will be an open curve.

Properties

  • Major radius: the major radius of the ellipse, the default value is 4
  • Minor radius: the minor radius of the ellipse, the default value is 2
  • Angle 1: start of the edge of the ellipse or elliptical curved edge, (degrees anti-clockwise), the default value is 0
  • Angle 2: end of the edge of the ellipse or elliptical curved edge, (degrees anti-clockwise), the default value is 360