Part CheckGeometry: Difference between revisions
Renatorivo (talk | contribs) (+ image) |
Renatorivo (talk | contribs) (Marked this version for translation) |
||
Line 11: | Line 11: | ||
If you want to enable the extra BOP checks then go to the Tools menu ... edit parameters...then navigate as per this screen shot below |
If you want to enable the extra BOP checks then go to the Tools menu ... edit parameters...then navigate as per this screen shot below |
||
<!--T:6--> |
|||
From the Part or Part Design WB |
From the Part or Part Design WB |
||
Revision as of 23:17, 30 October 2015
Part CheckGeometry |
Menu location |
---|
Part → Check geometry |
Workbenches |
Part |
Default shortcut |
None |
Introduced in version |
- |
See also |
None |
Introduction
The check geometry tool allows you to verify if you have a valid solid
Usage
If you want to enable the extra BOP checks then go to the Tools menu ... edit parameters...then navigate as per this screen shot below
From the Part or Part Design WB
Tools > Edit Parameters > Preferences > Mod > Part > CheckGeometry then in the right pane double click under Value for the RunBOPCheck parameter and set to true, then click Save to disk, close and restart.