PartDesign Sfera Substractivă
PartDesign SubtractiveSphere |
Menu location |
---|
Part Design → Create a subtractive primitive → Subtractive Sphere |
Workbenches |
PartDesign |
Default shortcut |
None |
Introduced in version |
- |
See also |
PartDesign CompPrimitiveSubtractive |
Descriere
Inserează o sferă substractivă în Corpul activ. forma sa este scăzută din solidul existent.
În partea stângă: corpul activ (A) afișat în gri și sfera substractivă (B) arătată în roșu transparent; rezultatul în partea dreaptă.
Cum se folosește
- Apăsați butonul Subtractive Sphere . Notă: Sfera Substractivă este partea meniului de iconițe numit Create an additive primitive. După lansarea FreeCAD, și Cubul Substractiv apare în bara de sintrumetne. Pentru a ajunge la Sferă click pe săgeata în dincolo de iconițele vizibile și selectați Subtractive Sphere din menu.
- Definiți parametrii Primitivei și Attachment.
- Click OK.
- O funcționalitate sferă apare sub Corpul activ
Opţiuni
The Sphere can be edited after its creation in two ways:
- Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
- Via the Property editor.
Proprietăți
- DateAttachment: defines the attachment mode as well as the Attachment Offset. See Part Attachment.
- DateLabel: Label given to the Sphere object. Change to suit your needs.
- DateRadius: Radius of the sphere.
- DateAngle1: (labelled V parameter in the Primitive parameters) lower truncation of the sphere, parallel to the circular cross section (-90 degrees in a full sphere)
- DateAngle2: (unlabelled in the Primitive parameters) upper truncation of the ellipsoid, parallel to the circular cross section (90 degrees in a full sphere).
- DateAngle3: (labelled U parameter in the Primitive parameters) angle of rotation of the cross section (360 degrees in a full sphere).