PartDesign Scaled/fr: Difference between revisions
(Updating to match new version of source page) |
(Updating to match new version of source page) |
||
Line 1: | Line 1: | ||
{{GuiCommand |
{{GuiCommand|Name=PartDesign Scaled|Workbenches=[[PartDesign Workbench|PartDesign]], Complete|MenuLocation=PartDesign → MultiTransform}} |
||
==Note== |
==Note== |
||
Line 26: | Line 26: | ||
==Limitations== |
==Limitations== |
||
* Scaling always happens with the centre of gravity of the feature as the base point. |
|||
* A scaled transformation should not be the first in the list |
|||
* L'{{KEY|[[File:PartDesign_Scaled.png|16px|text-top=Echelle|link=PartDesign_Scaled/fr]] [[PartDesign_Scaled/fr|Echelle]]}} a toujours comme centre de gravité, le point de base. |
|||
* The scaled transformation must have the same number of occurrences as the transformation immediately preceding it in the list |
|||
* Allez sur {{KEY|[[Image:PartDesign_LinearPattern.png|16px|text-top=Répétition Linéaire de Modéle|link=PartDesign_LinearPattern/fr]] [[ PartDesign_LinearPattern/fr| Répétition Linéaire de Modéle]]}}, pour voir les autres limitations. |
|||
* See [[PartDesign_LinearPattern|linear pattern feature]] for other limitations |
|||
* See [[PartDesign_MultiTransform|MultiTransform]] for more details |
|||
{{clear}} |
|||
{{LesOutilsDeTransformationsPartDesign}} |
|||
==Examples== |
==Examples== |
Revision as of 07:39, 10 October 2016
PartDesign Scaled |
Menu location |
---|
PartDesign → MultiTransform |
Workbenches |
PartDesign, Complete |
Default shortcut |
None |
Introduced in version |
- |
See also |
None |
Note
Since FreeCAD 0.15, this feature is not available directly, but is included as MultiTransform component
Introduction
L'outil Echelle : prend un ou plusieurs objet(s) sélectionné(s) comme entrée (les originaux), et, les transformes à un facteur d'échelles donné. Étant donné que l' Echelle, se construit autour du centre de gravité, des objets choisis, ils disparaissent habituellement à l'intérieur de la version de l'échelle. Donc, normalement il est seulement judicieux d'utiliser l' Echelle, dans le cadre de la fonction Transformation Multiple.
Options
Lorsque vous utilisez la fonction Echelle, la boîte de dialogue des paramètres d' Echelle, offre les options suivantes : Selection des originauxLa fenêtre affiche les originaux, des objets qui doivent être mis à l' Echelle. En cliquant sur un objet, il sera ajouté à la liste. Facteur et OccurrencesSpécifie le nombre et le facteur maximal à donner aux objets, qui vont être mis à l' Echelle, (y compris la sélection originale). |
Limitations
- Scaling always happens with the centre of gravity of the feature as the base point.
- A scaled transformation should not be the first in the list
- The scaled transformation must have the same number of occurrences as the transformation immediately preceding it in the list
- See linear pattern feature for other limitations
- See MultiTransform for more details
Examples
The smallest pad was first patterned three times in X direction and then scaled to factor two (so the three occurrences have scaling factor 1.0, 1.5 and 2.0). Then a polar pattern was applied with 8 occurrences.