PartDesign Draft/ro: Difference between revisions
No edit summary |
No edit summary |
||
Line 5: | Line 5: | ||
This tool creates angular draft on the selected faces of an object. A new separate Draft entry (followed by a sequential number if there are already existing drafts in the document) is created in the Project tree. |
This tool creates angular draft on the selected faces of an object. A new separate Draft entry (followed by a sequential number if there are already existing drafts in the document) is created in the Project tree. |
||
Acest instrument creează un draft unghiular pe fațetele selectate ale unui obiect. O nouă intrare Draft (urmată de un număr secvențial dacă există deja Draft în document) este creat în arborescența Proiectului. |
Acest instrument creează un draft unghiular pe fațetele selectate ale unui obiect. O nouă intrare Draft (urmată de un număr secvențial dacă există deja Draft în document) este creat în arborescența Proiectului. |
||
Acest instrument creează o pantă unghiulară (înclinarea fețelor) pe fețele selectate ale unui obiect. Structura proiectului creează o nouă intrare "Independent Draft", (urmată de un număr secvențial dacă există deja Drafts documentul) este creat în arborescența Proiectului. |
|||
{| |
{| |
Revision as of 10:35, 28 September 2018
PartDesign Draft |
Menu location |
---|
Part Design → Draft |
Workbenches |
Part Design |
Default shortcut |
None |
Introduced in version |
- |
See also |
None |
Descriere
This tool creates angular draft on the selected faces of an object. A new separate Draft entry (followed by a sequential number if there are already existing drafts in the document) is created in the Project tree. Acest instrument creează un draft unghiular pe fațetele selectate ale unui obiect. O nouă intrare Draft (urmată de un număr secvențial dacă există deja Draft în document) este creat în arborescența Proiectului. Acest instrument creează o pantă unghiulară (înclinarea fețelor) pe fețele selectate ale unui obiect. Structura proiectului creează o nouă intrare "Independent Draft", (urmată de un număr secvențial dacă există deja Drafts documentul) este creat în arborescența Proiectului.
Utilizare
Parametrii și OpțiuniAdaugă o Fațetă / Șterge o FațetăClick Add Face or Remove Face, then select a single face to update the list of active faces. Repeat as needed. Draft AngleSet the Draft Angle by entering a value or by clicking on the up/down arrows. The applied draft angle is shown in real time. Plan NeutruClick Neutral Plane, then select the plane that must not change dimensionally. The change is made in real time. Pull DirectionClick Pull Direction, then select an edge. Pull Direction is only effective if the Neutral Plane has been set. Results can be unpredictable. Reverse Pull DirectionChecking Reverse Pull Direction will toggle the draft between positive and negative angles. Cazuri specialeThe Draft tool will only function on faces that are normal to each other. If there are any tangential faces attached to the face you wish to apply draft to, it will fail. A common cause of failure is attempting to apply draft to a face that already has a fillet or chamfer applied to it. In this case, remove the tangential surface, apply the draft as need, then re-apply the fillet or chamfer. |