PartDesign Chamfer: Difference between revisions
(added usage) |
(removed extraneous list items) |
||
Line 14: | Line 14: | ||
=== Usage === <!--T:3--> |
=== Usage === <!--T:3--> |
||
# |
|||
# |
|||
# |
|||
* Select a single or multiple edges or a face on an object, then start the tool either by clicking its icon or going into the menu. In case you selected a face all its edges are respected for filleting. |
* Select a single or multiple edges or a face on an object, then start the tool either by clicking its icon or going into the menu. In case you selected a face all its edges are respected for filleting. |
||
* In Chamfer parameters in the TaskPanel, set the chamfer size either by entering the value, or by clicking on the up/down arrows. The applied chamfer is shown in real time. |
* In Chamfer parameters in the TaskPanel, set the chamfer size either by entering the value, or by clicking on the up/down arrows. The applied chamfer is shown in real time. |
Revision as of 06:19, 26 December 2018
PartDesign Chamfer |
Menu location |
---|
Part Design → Chamfer |
Workbenches |
PartDesign, Complete |
Default shortcut |
None |
Introduced in version |
- |
See also |
Chamfer Part |
Description
This tool creates chamfers (flat face at 45 degrees to both adjoining faces) on the selected edges of an object. A new separate Chamfer entry (followed by a sequential number if there are already existing fillets in the document) is created in the Project tree.
Usage
PartDesign Chamfer VS. Part Chamfer |