Measurement Of Angles On Holes: Difference between revisions
(Marked this version for translation) |
m (language bar) |
||
Line 1: | Line 1: | ||
<languages/> |
|||
<translate> |
<translate> |
||
Revision as of 19:10, 8 April 2020
Introduction
By creating angles for holes it's not possible to use vertical or horizontal center lines (false/true) from the properties of the view. Helping lines and/or helping points are necessary for creating.
Proceeding:
1.Setting center lines on holes:
There are some possibilities to create a center line for holes. At first the lines or points on the hole must be selected as shown below. Behind them the tool File:AnHi4.PNG or File:AnHi6.PNG from the tool bar is creating the center line.