Path Profilo
Profilo |
Posizione nel menu |
---|
Path → Nuove Operazioni → Profilo |
Ambiente |
Path |
Avvio veloce |
P,P |
Introdotto nella versione |
- |
Vedere anche |
Nessuno |
Descrizione
Questo strumento crea una operazione di profilatura, a partire da una faccia selezionata basata su un oggetto Parte.
Utilizzo
- Selezionare una faccia di un oggetto basato su Parte. In alternativa, selezionare il bordo iniziale di tale faccia.
- Premere il pulsante Profilo
- Regolare le proprietà desiderate
Opzioni
- L'oggetto Profilo di Path è fatto per essere una parte di un Progetto di Path. Per configurare correttamente la profilatura, nell'oggetto macchina del progetto deve essere presente una tabella utensile, e prima del Profilo deve essere posizionato un comando Utensile.
Proprietà
- DatiActive: Make False, to prevent operation from generating code
- DatiUse Placements: make True, if using the profile operation placement properties to transform toolpath in post processor
- DatiTool Number: The tool number in use
Proprietà di profondità
- DatiClearance Height: The height needed to clear clamps and obstructions
- DatiStep Down: Incremental Step Down of Tool
- DatiUse Start Depth: make True, if manually specifying a Start Start Depth
- DatiStart Depth: Starting Depth of Tool- first cut depth in Z
- DatiFinal Depth: Final Depth of Tool- lowest value in Z
- DatiRetract Height: The height desired to retract tool when path is finished
- DatiComment: An optional comment for this profile
Feed Properties
- DatiVert Feed: Feed rate for vertical moves in Z
- DatiHoriz Feed: Feed rate for horizontal moves
Start Point Properties
- DatiStart Point: The start point of this path
- DatiUse Start Point: make True, if specifying a Start Point
- DatiExtend At Start: extra length of tool path before start of part edge
- DatiLeadIn Line Len: length of straight segment of toolpath that comes in at angle to first part edge
End Point Properties
- DatiUse End Point: make True, if specifying an End Point
- DatiExtend At End: extra length of tool path after end of part edge
- DatiLeadOut LineLen: length of straight segment of toolpath that comes in at angle to last part edge
- DatiEnd Point: The end point of this path
Profile Properties
- DatiSide: Side of edge that tool should cut
- DatiDirection: The direction that the toolpath should go around the part ClockWise CW or CounterClockWise CCW
- DatiRollRadius: Radius at start and end
- DatiOffsetExtra: Extra value to stay away from final profile- good for roughing toolpath
- DatiSegLen: Tesselation value for tool paths made from beziers, bsplines, and ellipses