Path Profilo

From FreeCAD Documentation
Revision as of 16:44, 27 January 2016 by Renatorivo (talk | contribs) (Created page with "* L'oggetto Profilo di Path è fatto per essere una parte di un Progetto di Path. Per configurare correttamente la profilatura, nell'oggetto macchina del p...")

Profilo

Posizione nel menu
Path → Nuove Operazioni → Profilo
Ambiente
Path
Avvio veloce
P,P
Introdotto nella versione
-
Vedere anche
Nessuno

Descrizione

Questo strumento crea una operazione di profilatura, a partire da una faccia selezionata basata su un oggetto Parte.

Utilizzo

  1. Selezionare una faccia di un oggetto basato su Parte. In alternativa, selezionare il bordo iniziale di tale faccia.
  2. Premere il pulsante Profilo
  3. Regolare le proprietà desiderate

Opzioni

  • L'oggetto Profilo di Path è fatto per essere una parte di un Progetto di Path. Per configurare correttamente la profilatura, nell'oggetto macchina del progetto deve essere presente una tabella utensile, e prima del Profilo deve essere posizionato un comando Utensile.

Properties

  • DatiActive: Make False, to prevent operation from generating code
  • DatiUse Placements: make True, if using the profile operation placement properties to transform toolpath in post processor
  • DatiTool Number: The tool number in use

Depth Properties

  • DatiClearance Height: The height needed to clear clamps and obstructions
  • DatiStep Down: Incremental Step Down of Tool
  • DatiUse Start Depth: make True, if manually specifying a Start Start Depth
  • DatiStart Depth: Starting Depth of Tool- first cut depth in Z
  • DatiFinal Depth: Final Depth of Tool- lowest value in Z
  • DatiRetract Height: The height desired to retract tool when path is finished
  • DatiComment: An optional comment for this profile

Feed Properties

  • DatiVert Feed: Feed rate for vertical moves in Z
  • DatiHoriz Feed: Feed rate for horizontal moves

Start Point Properties

  • DatiStart Point: The start point of this path
  • DatiUse Start Point: make True, if specifying a Start Point
  • DatiExtend At Start: extra length of tool path before start of part edge
  • DatiLeadIn Line Len: length of straight segment of toolpath that comes in at angle to first part edge

End Point Properties

  • DatiUse End Point: make True, if specifying an End Point
  • DatiExtend At End: extra length of tool path after end of part edge
  • DatiLeadOut LineLen: length of straight segment of toolpath that comes in at angle to last part edge
  • DatiEnd Point: The end point of this path

Profile Properties

  • DatiSide: Side of edge that tool should cut
  • DatiDirection: The direction that the toolpath should go around the part ClockWise CW or CounterClockWise CCW
  • DatiRollRadius: Radius at start and end
  • DatiOffsetExtra: Extra value to stay away from final profile- good for roughing toolpath
  • DatiSegLen: Tesselation value for tool paths made from beziers, bsplines, and ellipses