CAM Pocket Shape/it: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
mNo edit summary
Line 11: Line 11:
==Utilizzo==
==Utilizzo==


# Selezionare una faccia o una parete inferiore di una tasca. Mentre di solito è più facile selezionare il fondo, le parete devono essere selezionati quando una tasca passa attraverso tutto.
<div class="mw-translate-fuzzy">
# Selezionare una faccia o una parete inferiore di una tasca
# Premere il pulsante {{KEY|[[Image:Path Pocket.png|16px]] [[Path Pocket_Shape/it|Tasca]]}}
# Premere il pulsante {{KEY|[[Image:Path Pocket.png|16px]] [[Path Pocket_Shape/it|Tasca]]}}
# Regolare le proprietà desiderate
# Regolare le proprietà desiderate
</div>


==Properties==
==Properties==

Revision as of 08:48, 4 June 2018

Tasca

Posizione nel menu
Path → Tasca
Ambiente
Path
Avvio veloce
P,O
Introdotto nella versione
-
Vedere anche
Nessuno

Descrizione

Questo strumento crea un'operazione di scavo basato sulle facce o sulle pareti inferiori selezionate in una o più tasche dell'oggetto in lavorazione.

L'oggetto Tasca di Path è fatto per essere parte di una Lavorazione.

Utilizzo

  1. Selezionare una faccia o una parete inferiore di una tasca. Mentre di solito è più facile selezionare il fondo, le parete devono essere selezionati quando una tasca passa attraverso tutto.
  2. Premere il pulsante Tasca
  3. Regolare le proprietà desiderate

Properties

Base Geometry

  • Add, if not allready done, the elements which should be the base for the path
    • you can also delete or change to other elements

Depth

  • DatiStart Depth: Starting Depth of Tool- starting depth in Z
  • DatiFinal Depth: Final Depth of Tool- lowest cutting level in Z
  • DatiFinish Depth: The hight of the last cutting level- set for a better finish
  • DatiStep Down: Step Down of Tool- the amount of material which will be removed at once

Height

  • DatiSafe Height: The hight above the workpeace where rapid motions are allowed.
  • DatiClearance Height: The height needed to clear clamps and obstructions

Operation

  • DatiTool Controller: Defines the Tool controller used in the Operation
  • DatiCut Mode: Specifies a CW or CCW move for the cut
  • DatiPattern: Select on which manner the horizontal movements should be done
  • DatiAngle: Select the path angle relativ to x axis
  • DatiStep Over Percent: Select the horizontal step over- 100% = tool diameter
  • DatiPass Extension: