Path Vestizione Trascina lama

From FreeCAD Documentation
Revision as of 18:20, 13 March 2018 by Renatorivo (talk | contribs) (Created page with "# Selezionare un contorno o un oggetto profilo Path # cliccare su 16px Vestizione Dragknife")

Vestizione Trascina lama

Posizione nel menu
Path → Vestizione → Trascina lama
Ambiente
Path
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Tag di vestizione, Rampa di ingresso, Vestizione Osso di cane

Descrizione

A drag knife uses a cutting edge on a pivot to cut sheet material like vinyl, cardboard, and leather. The cutting point is not aligned with the center of the spindle but rather follows it as the spindle moves. Because the cutting point is offset, the path must be modified to extend past the endpoint of each segment. Also, the dragknife is incapable of making extremely tight turns. To compensate, a pivot 'corner action' is inserted which momentarily lifts the blade slightly and then pivots into the new postion.

Questo strumento veste un tracciato esistente per aggiungere azioni angolari ed estensioni dei bordi per il taglio con lama.

Utilizzo

  1. Selezionare un contorno o un oggetto profilo Path
  2. cliccare su Vestizione Dragknife

Options

  • Filter Angle - Determines how acute an angle must be before a corner action is inserted.
  • Offset - Input how much the blade point is offset from the spindle center.
  • Pivot Height - Determines how high to lift the cutting blade during a corner action. This is material dependent and should be higher for thicker materials. Ideally, the point should remain in the material slightly.