PartDesign Cono additivo
Cono additivo |
Posizione nel menu |
---|
Part Design → Crea una primitiva additiva → Cono |
Ambiente |
PartDesign |
Avvio veloce |
Nessuno |
Introdotto nella versione |
- |
Vedere anche |
Primitive additive |
Descrizione
Inserisce un cono primitivo nel corpo attivo come prima caratteristica o lo fonde con le caratteristiche esistenti.
disponibile dalla versione 0.17
How to use
- Press the Additive Cone button. Note: the Additive Cone is part of an icon menu labelled Create an additive primitive. After launching FreeCAD, the Additive Box is the one displayed in the toolbar. To get to the Cone button, click on the down arrow besides the visible icon and select Additive Cone in the menu.
- Set the Primitive parameters and Attachment.
- Click OK.
- A Cone feature appears under the active Body.
Options
The Cone can be edited after its creation in two ways:
- Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
- Via the Property editor.
Properties
- DatiAttachment: defines the attachment mode as well as the Attachment Offset. See Part Attachment.
- DatiLabel: label given to the Cone object. Change to suit your needs.
- DatiRadius1: the radius value at the cone's base.
- DatiRadius2: the radius value at the cone's top. A non-zero value creates a truncated cone.
- DatiHeight: the height of the cone along its axis.
- DatiAngle: angle of rotation of the cross section (360 degrees in a full cone).