Тор
Тор |
Системное название |
---|
Part Torus |
Расположение в меню |
Деталь → Primitives → Тор |
Верстаки |
Part, Complete |
Быстрые клавиши |
Нет |
Представлено в версии |
- |
См. также |
Создать примитивы |
Description
Creates a simple parametric torus, with position, angle1, angle2, angle3, radius1 and radius2 as parameters.
How to use
In the Part workbench click on the torus icon . The torus will be positioned at origin (point 0,0,0) on creation. The angle parameters (angle1, angle2, angle3), as well as the radius parameter (radius1 , radius2) parameters permit to parametrize the torus, see next paragraph.
Option
Parameter
A torus can be assimilated to a small disc that makes a circular orbit around an imaginary axe. Thus the parametric torus is defined by the following parameters:
- Radius1: Radius of the circle around which the disc circulate
- Radius2: Radius of the disc defining the form of the torus
- Angle1: 1st angle to cut / define the disc of the torus
- Angle2: 2nd angle to cut / define the disc of the torus
- Angle3: 3rd angle to define the circumference of the torus.
as well as the standard set of placement parameters. The pictures below give a visual overview of the parameters antecedently mentioned:
The parameter Radius1 has a value of 20 mm.
The parameter Radius2 has a value of 2 mm.
The parameter Angle1 has a value of -90°. Notice that, the "angle measure" tool cannot display negative angle. Considered the displayed value in picture as "-90°".
The parameter Angle2 has a value of 90°.
The parameter Angle3 has a value of 90°.