PartDesign Sfera additiva
Sfera additiva |
Posizione nel menu |
---|
Part Design → Crea una primitiva additiva → Sfera |
Ambiente |
PartDesign |
Avvio veloce |
None |
Introdotto nella versione |
- |
Vedere anche |
Primitive additive |
Descrizione
Inserisce una sfera primitiva nel corpo attivo come prima caratteristica o la fonde con le caratteristiche esistenti.
disponibile dalla versione 0.17
Utilizzo
- Premere il pulsante Sfera additiva. Nota: La sfera additiva fa parte di un menu di icone etichettato Crea una primitiva additiva. Dopo l'avvio, FreeCAD visualizza Cubo additivo nella barra degli strumenti. Per accedere alla sfera, fare clic sulla freccia verso il basso accanto all'icona visibile e selezionare Sfera nel menu.
- Impostare i parametri della primitiva e Associazione.
- Cliccare OK.
- Nel corpo attivo viene visualizzata una funzione Cuneo.
Opzioni
The Sphere can be edited after its creation in two ways:
- Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
- Via the Property editor.
Properties
- DatiAttachment: defines the attachment mode as well as the Attachment Offset. See Part Attachment.
- DatiLabel: Label given to the Sphere object. Change to suit your needs.
- DatiRadius: Radius of the sphere.
- DatiAngle1: (labelled V parameter in the Primitive parameters) lower truncation of the sphere, parallel to the circular cross section (-90 degrees in a full sphere)
- DatiAngle2: (unlabelled in the Primitive parameters) upper truncation of the ellipsoid, parallel to the circular cross section (90 degrees in a full sphere).
- DatiAngle3: (labelled U parameter in the Primitive parameters) angle of rotation of the cross section (360 degrees in a full sphere).