PartDesign: Scala
|
Menu location |
---|
PartDesign → MultiTransform |
Workbenches |
PartDesign, Complete |
Default shortcut |
None |
Introduced in version |
- |
See also |
None |
Note
Since FreeCAD 0.15, this feature is not available directly, but is included as MultiTransform component
Lo strumento Scala prende come input un insieme di una o più operazioni selezionate ('gli originali') e li scala per un determinato fattore. Poiché la scalatura avviene attorno al centro di gravità delle operazioni selezionate, di solito gli originali scompaiono all'interno delle versioni in scala. Pertanto, in genere è utile solo per effettuare il ridimensionamento come parte di una operazione di MultiTrasformazione.
Opzioni
Limitations
- Scaling always happens with the centre of gravity of the feature as the base point.
- A scaled transformation should not be the first in the list
- The scaled transformation must have the same number of occurrences as the transformation immediately preceding it in the list
- See linear pattern feature for other limitations
- See MultiTransform for more details
Examples
![c](/images/thumb/9/93/Mt_example2.png/800px-Mt_example2.png)
The smallest pad was first patterned three times in X direction and then scaled to factor two (so the three occurrences have scaling factor 1.0, 1.5 and 2.0). Then a polar pattern was applied with 8 occurrences.