Translations:PartDesign Revolution/9/en

From FreeCAD Documentation

Note: Unlike the above, all these examples below refer to Base, Axis and Placement being edited directly through the feature properties table.

Example revolution 1: In this image the angle has been set to 70°, revolution is about the x-axis and there is a y-offset of 100mm. The sketch is the face not shown in the image (i.e. the 'back' face).
Example revolution 2: In this image the angle is 70°, revolution is about the y-axis and there is a y-offset of 100mm.
Example revolution 3: In this image the angle is 270°, revolution is about the x-axis and there are 0 offsets
Example revolution 4: In this image the angle is 270°, revolution is about the x-axis (value 1.00) and the y-axis (value 2.00) and there is a y-offset of 100mm