Translations:Glossary/4/ko

From FreeCAD Documentation
0-9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z (Top)
DAG
See Directed Acyclic Graph.
Degrees Of Freedom (자유도)
The number of ways geometry in a Sketch may vary. 예를 들어 하나의 점으로만 구성된 스케치가 있고 이 점에 구속 (Constraint)이 적용되지 않은 경우, 이 점은 수직과 수평 모두 자유롭게 움직일 수 있으므로 두 개의 자유도(DOF)를 가집니다. 마찬가지로 구속이 없는 단일 원으로만 구성된 스케치는 원이 수직 및 수평으로 움직일 수 있고 반경이 정의되지 않았기 때문에 자유도가 3입니다. 자유도가 더 이상 남아 있지 않을 때까지 스케치를 제한하는 것이 좋습니다. 이 경우 (완전히 구속Fully Constrained)되었다고 합니다.
Dependency Graph
A third-party graphing tool used to show how objects in a FreeCAD model use or are related to one another. For more information, refer to the Dependency Graph Wiki page.
Difference
1.  The result of, or remainder of, a subtraction.
2.  A Boolean Operation in the Part workbench which is used to subtract one geometry from another; it results in a Cut.
Directed Acyclic Graph (abbreviated as "DAG")
A type of Dependency Graph where the relationship of objects flows in a generally linear direction from start to end with no circular dependencies. When following a DAG there is no flow from one object A to any other objects and then back to that same object A again. In FreeCAD, a graph of the model must always be a DAG.
DOF (자유도)
자유도(Degrees Of Freedom)의 약어
Draft
1.  A FreeCAD workbench used primarily for 2 dimensional work.
2.  A relief angle on a mold to allow removal of the finished product. See PartDesign Draft.
Drawing
Describes a representation of geometry through the use of two-dimensional views. Also called plan or blueprint.