Translations:Manual:Modeling for product design/44/en

From FreeCAD Documentation
Revision as of 02:57, 25 July 2016 by FuzzyBot (talk | contribs) (Importing a new version from external source)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

But the best of both worlds also exists, which is the Assembly2 Workbench, an addon that can be installed from the FreeCAD-addons repository. This Workbench is named "2" because there is also an official built-in Assembly Workbench in development, which is not ready yet. The Assembly2 Workbench, however, already works very well to construct assemblies, and also features a couple of object-to-object constraints which you can use to constrain the position of one object in relation to another. In the example below, however, it will be quicker and easier to position the pieces using Draft Move and Draft Rotate than using the Assembly2 constraints.