Information about message (contribute ) This message has no documentation.
If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Draft Edit ) * To manually enter coordinates enter the X, Y and Z component, and press {{KEY|Enter}} after each. Or you can press the {{Button|[[Image:Draft_AddPoint.svg|16px]] Enter Point}} button when you have the desired values. It is advisable to move the pointer out of the [[3D_View|3D View]] before entering coordinates. * To use polar coordinates enter a value for the {{MenuCommand|Length}} and a value for the {{MenuCommand|Angle}}, and press {{KEY|Enter}} after each. * Check the {{MenuCommand|Angle}} checkbox to constrain the pointer to the specified angle. * Press {{KEY|R}} or click the {{MenuCommand|Relative}} checkbox to toggle relative mode. If relative mode is on, the coordinates of the picked point are relative to the original point, else they are relative to the coordinate system origin. {{Version|1.0}} * Press {{KEY|G}} or click the {{MenuCommand|Global}} checkbox to toggle global mode. If global mode is on, coordinates are relative to the global coordinate system, else they are relative to the [[Draft_SelectPlane|working plane]] coordinate system. * Press {{KEY|S}} to switch [[Draft_Snap|Draft snapping]] on or off.
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you
log in or
create an account , your edits will be attributed to your username, along with other benefits.