Translations:Draft Circle/5/cs: Difference between revisions

From FreeCAD Documentation
(Created page with "==Volby== * Základní způsob použití nástrije Kružnice je zadáním dvou bodů, středu a bodu na obvodu kružnice, který definuje poloměr. * Stiskem {{KEY|ALT}} můž...")
(No difference)

Revision as of 17:07, 20 January 2014

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Draft Circle)
* To manually enter the coordinates for the center enter the X, Y and Z component, and press {{KEY|Enter}} after each. Or you can press the {{Button|[[Image:Draft_AddPoint.svg|16px]] Enter point}} button when you have the desired values. It is advisable to move the pointer out of the [[3D_view|3D view]] before entering coordinates.
* Press {{KEY|G}} or click the {{MenuCommand|Global}} checkbox to toggle global mode. If global mode is on, coordinates are relative to the global coordinate system, else they are relative to the [[Draft_SelectPlane|working plane]] coordinate system. {{Version|0.20}}
* Press {{KEY|F}} or click the {{MenuCommand|Filled}} checkbox to toggle filled mode. If filled mode is on, the created circle will have {{PropertyData|Make Face}} set to {{TRUE}} and will have a filled face.
* Press {{KEY|N}} or click the {{MenuCommand|Continue}} checkbox to toggle continue mode. If continue mode is on, the command will restart after finishing, allowing you to continue creating circles.
* Press {{KEY|S}} to switch [[Draft_Snap|Draft snapping]] on or off.
* Press {{KEY|Esc}} or the {{Button|Close}} button to abort the command.

Volby

  • Základní způsob použití nástrije Kružnice je zadáním dvou bodů, středu a bodu na obvodu kružnice, který definuje poloměr.
  • Stiskem ALT můžete vybrat tečnu místo zadání druhého bodu. Můžete tak zkonstruovat několik typů kružnic výběrem jedné dvou nebo tří tečen.
  • Chcete-li zadat souřadnice ručně, jdenoduše vkládejte čísla a stiskněte ENTER mezi každou z komponent X, Y a Z.
  • Stiskněte klávesu T nebo klikněte na zaklikávací políčko pro zatrhnutí nebo odtrhnutí tlačítka Pokračovat. Je-li nastaven pokračovací mód, bude nástroj Kružnice hned po zadání druhého bodu připraven ke kreslení další kružnice bez nutnosti stisknout znovu tlačítko Kružnice.
  • Press CTRL while drawing to force snapping your point to the nearest snap location, independently of the distance.
  • Press SHIFT while drawing to constrain your second point horizontally or vertically in relation to the first one.
  • Press I or the Filled button to have the circle to appear as a face after it has been closed. This simply sets the View->Property of the Circle to "Flat lines" or "Wireframe", so it can easily be changed later.
  • Press ESC or the Cancel button to abort the current Line command.
  • The circle can be turned into an arc after creation, by setting its first angle and last angle properties to different values.