Reinforcement UShapeRebar

From FreeCAD Documentation
Revision as of 08:51, 13 August 2017 by Amrit3701 (talk | contribs)

Arch Rebar UShape

Menu location
Arch → Rebar tools
Workbenches
Arch
Default shortcut
None
Introduced in version
-
See also
Arch Rebar

Description

The UShape Rebar tool allows user to create a UShape reinforcing bar in the structural element.

How to use

  1. Create a structure element
  2. Select any face of the structure
  3. Then select UShape Rebar from the rebar tools
  4. A task panel will pop-out on the left side of the screen
  5. Select the desired orientation
  6. Give the inputs like front cover, right side cover, left side cover, bottom cover, top cover, rounding factor and diameter of the rebar
  7. Select the mode of distribution either amount or spacing
  8. If spacing is selected, a user can also opt for custom spacing
  9. Pick selected face is used to verify or change the face for rebar distribution
  10. Click OK or Apply to generate the rebars
  11. Click Cancel to exit the task panel

Properties

  • DataOrientation: It decides the orientation of the rebar (like a bottom, top, right and left).
  • DataFront Cover: The distance between rebar and selected face.
  • DataRight Cover: The distance between the right end of the rebar to right face of the structure.
  • DataLeft Cover: The distance between the left end of the rebar to the left face of the structure.
  • DataBottom Cover: The distance between rebar from the bottom face of the structure.
  • DataTop Cover: The distance between rebar from the top face of the structure.
  • DataRounding: A rounding value to be applied to the corners of the bars, expressed in times the diameter.
  • DataAmount: The amount of rebars.
  • DataSpacing: The distance between the axes of each bar.