Reinforcement UShapeRebar

From FreeCAD Documentation
Revision as of 20:19, 12 August 2017 by Amrit3701 (talk | contribs) (Created page with "==How to use== <!--T:6--> <!--T:7--> # Create a structure element # Select any face of the structure # Then select {{KEY|16px US...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

How to use

  1. Create a structure element
  2. Select any face of the structure
  3. Then select UShape Rebar from the rebar tools
  4. A task panel will pop-out on the left side of the screen
  5. Select the desired orientation
  6. Give the inputs like front cover, right side cover, left side cover, bottom cover, top cover, rounding factor and diameter of the rebar
  7. Select the mode of distribution either amount or spacing
  8. If spacing is selected, a user can also opt for custom spacing
  9. Pick selected face is used to verify or change the face for rebar distribution
  10. Click OK or Apply to generate the rebars
  11. Click Cancel to exit the task panel