Part: Cerchio

From FreeCAD Documentation
Revision as of 18:19, 30 May 2014 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Cerchio

Posizione nel menu
Parte → Crea primitive → Cerchio
Ambiente
Parte, OpenSCAD
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
..


Dal dialogo Crea Primitive de'ambiente Parte è disponibile un cerchio geometrico primitivo .

Il dialogo Crea Primitive è accessibile tramite l'icona Crea Primitive del menu Part o della barra degli Strumenti Part, dell'ambiente Part.

This command will create a circular curved edge. With the default values, the circular curved edge will be closed and therefore will be a circle. If the properties Angle 0 or Angle 1 are changed from their default values (0 and 360) the edge will be an open curve, an arc.

Alternatively a Part Circle can be initially defined from three points. Once created the circle will only contain the standard Part Circle properties and will no longer contain a reference to the creation points.


Crea un cerchio o un settore di cerchio parametrico.

Utilizzare il menu Template:KEY/it. Si apre una finestra di dialogo che consente di impostare:

Primitive Geometriche

Cerchio

Parametri

  • Raggio
  • Angolo 1
  • Angolo 2
  • Da tre punti

Posizione

Espandere la voce Posizione per stabilire:

  • punto di posizionamento nella vista 3D, di default il centro del cerchio viene posto nel punto 0,0,0
  • direzione dell'asse del cerchio, x, y, z o definita dall'utente.

I parametri e il posizionamento sono modificabili tramite la scheda delle proprietà.

  • Radius: the radius of the curved edge (arc or circle)
  • Angle 0: start of the curved edge, (degrees anti-clockwise), the default value is 0
  • Angle 1: end of the curved edge, (degrees anti-clockwise), the default value is 360