PartDesign: Con Aditiv

From FreeCAD Documentation
Revision as of 08:32, 3 October 2018 by Luc (talk | contribs)

PartDesign AdditiveCone

Menu location
Part Design → Create an additive primitive → Additive Cone
Workbenches
PartDesign
Default shortcut
None
Introduced in version
-
See also
PartDesign CompPrimitiveAdditive

Descriere

Inserează o primitivă geometrică tip con în corpul activ ca prima funcție(onalitate) sau se conectează la funcționalitățile existente.

introduced in version 0.17

Cum se folosește

  1. Apăsați butonul Additive Cone. Notă: Conul Aditiv este parte a meniului cu iconițe numit Create an additive primitive. După lansrea FreeCAD, Caseta Aditivă este afișată în bara de instrumente. Pentru a ajunge la butonul Cone, faceți clic pe săgeata în jos dincolo de iconițele vizibile și selectați în meniu Additive Cone .
  2. Definiți parametrii Primivei geometrice și Attachment.
  3. Click pe OK.
  4. O funcționalitate Cone apare sub Corpul (Body) activ.

Opţiuni

The Cone can be edited after its creation in two ways:

  • Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
  • Via the Property editor.

Proprietăți

  • DateAttachment: defines the attachment mode as well as the Attachment Offset. See Part Attachment.
  • DateLabel: label given to the Cone object. Change to suit your needs.
  • DateRadius1: the radius value at the cone's base.
  • DateRadius2: the radius value at the cone's top. A non-zero value creates a truncated cone.
  • DateHeight: the height of the cone along its axis.
  • DateAngle: angle of rotation of the cross section (360 degrees in a full cone).