Draft Snap Parallel/de: Difference between revisions
(Created page with "{{GuiCommand/de|Name=Draft Parallel|Workbenches=Draft, Arch|MenuLocation=Draft → Snap → Parallel|Shortcut=|SeeAlso=}}") |
(Updating to match new version of source page) |
||
Line 1: | Line 1: | ||
⚫ | |||
{{GuiCommand/de|Name=Draft Parallel|Workbenches=[[Draft Module|Draft]], [[Arch Module|Arch]]|MenuLocation=Draft → [[Draft Snap|Snap]] → Parallel|Shortcut=|SeeAlso=}} |
{{GuiCommand/de|Name=Draft Parallel|Workbenches=[[Draft Module|Draft]], [[Arch Module|Arch]]|MenuLocation=Draft → [[Draft Snap|Snap]] → Parallel|Shortcut=|SeeAlso=}} |
||
Line 27: | Line 28: | ||
{{clear}} |
{{clear}} |
||
⚫ |
Revision as of 21:01, 2 August 2018
Draft Parallel |
Menüeintrag |
---|
Draft → Snap → Parallel |
Arbeitsbereich |
Draft, Arch |
Standardtastenkürzel |
Keiner |
Eingeführt in Version |
- |
Siehe auch |
Keiner |
Description
This snap mode lets you select a point on an imaginary line parallel to a line segment.
Use
- Make sure snap mode is turned on
- Choose element to be inserted into the FreeCAD-document
On Linux
- Move cursor over the desired object to activate its parallel snap
- Move cursor until below on the right side of the cursor the symbol of the snap mode will appear
- Click to place your element parallel to selected object
On WIndows
- Press CTRL and move cursor over the desired object to activate its parallel snap
- Move cursor until below on the right side of the cursor the symbol of the snap mode will appear
- Click to place your element parallel to selected object
Works also with Draft Move and Draft Rotate
Notes
Snap mode can be used with
- sketcher elements (lines, arcs)
- draft elements (DWires, Lines, Arcs)
Clicking on the snap-mode icon will toggle the snap mode on/off.