Draft Snap Angle/de: Difference between revisions
(Created page with "{{GuiCommand/de|Name=Draft Angle|Workbenches=Draft, Arch|MenuLocation=Draft → Snap → Angle|Shortcut=|SeeAlso=}}") |
(Updating to match new version of source page) |
||
Line 1: | Line 1: | ||
⚫ | |||
{{GuiCommand/de|Name=Draft Angle|Workbenches=[[Draft Module|Draft]], [[Arch Module|Arch]]|MenuLocation=Draft → [[Draft Snap|Snap]] → Angle|Shortcut=|SeeAlso=}} |
{{GuiCommand/de|Name=Draft Angle|Workbenches=[[Draft Module|Draft]], [[Arch Module|Arch]]|MenuLocation=Draft → [[Draft Snap|Snap]] → Angle|Shortcut=|SeeAlso=}} |
||
Line 23: | Line 24: | ||
{{clear}} |
{{clear}} |
||
⚫ |
Revision as of 20:36, 2 August 2018
Draft Angle |
Menüeintrag |
---|
Draft → Snap → Angle |
Arbeitsbereich |
Draft, Arch |
Standardtastenkürzel |
Keiner |
Eingeführt in Version |
- |
Siehe auch |
Keiner |
Description
Snaps to the special cardinal points of circles and arcs, at 45° and 90°.
Use
- Make sure snap mode is turned on
- Choose element to be inserted into the FreeCAD-document
- Move cursor near one of the cardinal point you wish to attach your element to
- Below on the right side of the cursor the symbol of the snap mode will appear
- Click to attach your element to the selected endpoint of target element
Will also work with Draft Move and Draft Rotate.
Notes
Snap mode can be used with
- sketcher elements (arcs, circles)
- draft elements (arcs, circles)
- edge of circular face of shape
- edge of circular face of solid
Clicking on the snap-mode icon will toggle the snap mode on/off.