All translations

Enter a message name below to show all available translations.

Message

Found 6 translations.

NameCurrent message text
 h Deutsch (de)[[File:Loft B-spline.png|thumb|400px|Eine Spline-Interpolationskurve (rot), die der Ausformungsoberfläche folgt. Die Punkte, durch die interpoliert werden soll, sind als rote Quadrate dargestellt.]]
Wenn es nur zwei Profile gibt, sind die erzeugten Flächen Regelflächen zwischen den entsprechenden Segmenten der Profile. Es werden gerade Kanten erzeugt, um die entsprechenden Eckpunkte der Profile zu verbinden.
 h English (en)[[File:Loft B-spline.png|thumb|400px|A spline interpolation curve (red) that follows the loft surface. The points to interpolate through are shown as red squares.]]
If there are only two profiles, the surfaces created are ruled surfaces between corresponding segments of the profiles. Straight edges are created to connect corresponding vertices of the profiles.
 h français (fr)[[File:Loft B-spline.png|thumb|400px|Une courbe d'interpolation spline (rouge) qui suit la surface du lissage. Les points à interpoler sont représentés par des carrés rouges.]]
S'il n'y a que deux profils, les surfaces créées sont des surfaces réglées entre les segments correspondants des profils. Les arêtes droites sont créées pour connecter les sommets correspondants des profils.
 h italiano (it)===Fase 3. Creare la superficie Loft.===
[[File:Loft B-spline.png|thumb|400px|Esempio di una curva di interpolazione spline (rossa) che segue la superficie Loft. I punti attraverso cui è interpolata sono visualizzati come quadrati rossi.]]
Se ci sono solo due profili, le superfici create sono delle superfici rigate tra i segmenti corrispondenti dei profili. Per collegare i vertici corrispondenti dei profili vengono creati dei bordi dritti.
 h polski (pl)[[File:Loft B-spline.png|thumb|400px|Krzywa interpolacji spline ''(czerwona)'', która podąża za powierzchnią wyciągnięcia. Punkty, przez które należy interpolować, są pokazane jako czerwone kwadraty.]]
Jeśli istnieją tylko dwa profile, utworzone powierzchnie są powierzchniami rządzonymi pomiędzy odpowiadającymi im segmentami profili. Krawędzie proste są tworzone w celu połączenia odpowiednich wierzchołków profili.
 h română (ro)===Pasul 3. Making the loft surface.===
[[File:Loft B-spline.png|thumb|400px|A spline interpolation curve (red) that follows the loft surface. The points to interpolate through are shown as red squares.]]
Dacă există doar două profiluri, suprafețele create sunt suprafețe riglate între segmentele corespunzătoare ale profilurilor. Muchiile/marginile drepte sunt create pentru a conecta vârfurile corespunzătoare ale profilurilor.