All translations

Enter a message name below to show all available translations.

Message

Found 4 translations.

NameCurrent message text
 h Deutsch (de)Der Befehl [[Image:Fasteners_MatchTypeInner.svg|24px]] '''Fasteners AuswahlNachInnenmaß''' funktioniert mit dem Befehl [[Fasteners_MatchTypeOuter|Fasteners AuswahlNachAußenmaß]] wie ein Umschalter. 
Wenn '''Fasteners AuswahlNachInnenmaß''' ausgewählt ist, werden kreisförmige Kanten als Gewindebohrungen (Kernloch) angesehen, wenn ihnen neue Verbindungselemente hinzugefügt werden. Hieraus ergeben sich die Abmessungen der Verbindungselemente. Diese Einstellungen werden nicht für Senkschrauben verwendet.
 h English (en)The [[Image:Fasteners_MatchTypeInner.svg|24px]] '''Fasteners MatchTypeInner''' command behaves as a toggle with the [[Fasteners_MatchTypeOuter|Fasteners MatchTypeOuter]] command. When '''Fasteners MatchTypeInner''' is selected, circular edges are considered to be tap holes when new fasteners are attached to them. This determines the default dimensions of those fasteners. This setting is not used for countersunk screws.
 h français (fr)La commande [[Image:Fasteners_MatchTypeInner.svg|24px]] '''Fasteners Adapter pour le trou taraudé''' se comporte comme une bascule avec la commande [[Fasteners_MatchTypeOuter/fr|Fasteners Adapter pour le trou de passage]]. Lorsque la commande '''Fasteners Adapter pour le trou taraudé''' est sélectionnée, les bords circulaires sont considérés comme des trous taraudés lorsque de nouvelles fixations y sont fixées. Cela détermine les dimensions par défaut de ces fixations. Ce paramètre n'est pas utilisé pour les vis à tête fraisée.
 h polski (pl)Polecenie [[Image:Fasteners_MatchTypeInner.svg|24px]] '''Dopasowanie otworu pod gwint''' zachowuje się jak przełącznik z poleceniem [[Fasteners_MatchTypeOuter/pl|Dopasowanie otworu jako przelotowego]]. Gdy wybrane jest polecenie '''Dopasowanie otworu pod gwint''', okrągłe krawędzie są uważane za otwory gwintowane, gdy dołączane są do nich nowe elementy złączne. Określa to domyślne wymiary tych elementów złącznych. To ustawienie nie jest używane dla śrub z łbem stożkowym.