All translations

Enter a message name below to show all available translations.

Message

Found 2 translations.

NameCurrent message text
 h English (en)# Initiate a [[#Basic_Operation|Basic Operation]] as described above and set the '''Scan Type''' to '''Rotational'''.
# '''Note:''' Face selection is unavailable for Rotational scans, so changes to Base Geometry are ignored.
# Locate the Data tab and Properties View for the new [[CAM_Surface|3D Surface]] operation.  A '''Rotation''' section should be available with additional properties to adjust, listed below.<BR>It is recommended that you set the desired rotation properties all at once before recomputing. This is done by clicking the ENTER key immediately after changing a property setting. This process will allow you to change and save multiple properties before recomputing the operation.
# Adjust the following settings as needed:
#* Set {{PropertyData|Cutter Tilt}} to the offset index(angle) [0-90]. (Used for ball mill cutters)
#* Change {{PropertyData|Drop Cutter Dir}} to the axis of travel for the cutter(spindle).
#* Change {{PropertyData|Drop Cutter Extra Offset}} to extend the BoundBox in the X and Y directions.
#* Set {{PropertyData|Rotation Axis}} to the desired axis.
#* Adjust {{PropertyData|Start Index}} to start index(angle) [0-360].
#* Adjust {{PropertyData|Stop Index}} to stop index(angle) [0-360].
# Click the {{KEY|[[File:View-refresh.svg|16px]] [[Std_Refresh|Refresh]]}} icon in the tool bar.
# Wait for the results...
 h français (fr)# Lancez une [[#Op.C3.A9ration_de_base|opération de base]] comme décrit ci-dessus et définissez le '''Type de balayage''' à '''Rotationnel'''.
# '''Remarque :''' la sélection de face n'est pas disponible pour les balayages rotationnels, les modifications apportées à la géométrie de base sont donc ignorées.
# Localisez l'onglet Données et la vue Propriétés pour la nouvelle opération de [[CAM_Surface/fr|Surfaçage 3D]]. Une section '''Rotation''' devrait être disponible avec des propriétés supplémentaires à ajuster, listées ci-dessous.<br>
Il est recommandé de définir toutes les propriétés de rotation souhaitées en une seule fois avant de recalculer. Pour ce faire, cliquez sur la touche ENTRÉE immédiatement après avoir modifié un paramètre de propriété. Ce processus vous permettra de modifier et d'enregistrer plusieurs propriétés avant de recalculer l'opération.
# Ajustez les paramètres suivants selon vos besoins:
#* Définissez {{PropertyData|Cutter Tilt}} sur l'index de décalage (angle) [0-90]. (Utilisé pour les fraises hémisphériques)
#* Remplacez {{PropertyData|Drop Cutter Dir}} par l'axe de déplacement de la fraise (broche).
#* Modifiez {{PropertyData|Drop Cutter Extra Offset}} pour étendre la boîte de délimitation dans les directions X et Y.
#* Définissez {{PropertyData|Rotation Axis}} sur l'axe souhaité.
#* Ajustez {{PropertyData|Start Index}} pour démarrer l'index (angle) [0-360].
#* Ajustez {{PropertyData|Stop Index}} pour arrêter l'index (angle) [0-360].
# Cliquez sur l'icône {{KEY|[[File: View-refresh.svg|16px]] [[Std_Refresh/fr|Rafraîchir]]}} dans la barre d'outils.
# Attendez les résultats ...