Translations:PartDesign Groove/8/en

From FreeCAD Documentation
Revision as of 11:41, 11 April 2022 by FuzzyBot (talk | contribs) (Importing a new version from external source)
  1. Select the sketch to be revolved.
    A face on the existing solid can alternatively be used. version 0.17 and above
    The sketch must be mapped to the planar face of an existing solid or Part Design feature, or an error message will appear. version 0.16 and below
  2. Press the Groove button.
  3. Set the Groove parameters (see next section).
  4. Press OK.