Sketcher "Структурная копия"

From FreeCAD Documentation
Revision as of 09:36, 21 October 2020 by Baritone (talk | contribs)

Структурная Копия

Системное название
Sketcher Carbon Copy
Расположение в меню
Эскиз → Геометрия эскиза → Структурная Копия
Верстаки
Sketcher
Быстрые клавиши
Нет
Представлено в версии
0.17
См. также
Нет


Описание

Инструмент Структурная Копия копирует всю геометрию и ограничения из другого эскиза в активный эскиз.

Размерные ограничения, которые существовали до применении функции копирования останутся связанными с размерными ограничениями исходного эскиза через выражения.

Использование

  1. Убедитесь, что Вы в режиме редактирования текущего Эскиза.
  2. Нажмите кнопку Структурная Копия.
  3. Нажмите на ребро другого эскиза.
  4. Элементы геометрии, а также ограничения cкопируются в активный эскиз.
  5. Нажатие ESC или правой кнопки мыши заканчивает операцию.

Notes:

  • When sketches are used in the PartDesign Workbench, normally the sketch to carbon copy should be in the same PartDesign Body as the currently active sketch. If the sketch to be copied is not in the active Body, the mouse pointer will not allow selection. In this case, hold Ctrl to allow selection of sketches from other Bodies.
  • Normally, the sketch to select should be in a plane that is parallel to the currently active sketch. If the sketch to be copied is not parallel to the currently active sketch, hold Ctrl+Alt to allow selection of non-parallel sketches. The object will then be adjusted to the active sketch's plane. Noteː as of this writing this needs a save and reload of the document to make it visible. This works for sketches located outside of the currently active Body as well.
  • If the Sketcher mode has been changed to construction mode using Toggle Construction all copied geometry will be created in construction mode.

Ограничения

  • Копируется все содержание эскиза; Невозможно выбрать только его часть.