Translations:Sketcher CreateBSpline/6/en

From FreeCAD Documentation
  1. There are several ways to invoke the tool:
  2. The cursor changes to a cross with the tool icon.
  3. Pick several control points.
  4. While the tool is active a small construction circle is created centered on each point.
  5. Optionally press D before finishing the input to define the degree of the B-spline.
  6. Optionally press Backspace before finishing the input to delete the last control point.
  7. Right-click or press Esc to finish the input.
  8. The B-spline is created, including a set of internal geometry (weight circles and knot points).
  9. If the tool runs in continue mode:
    1. Optionally keep creating B-splines.
    2. To finish, right-click or press Esc, or start another geometry or constraint creation tool.