Translations:SheetMetal SketchOnSheet/25/en
- Create a folded sheet metal object
- Select the contour sketch
- Press the Make Base Wall button
or use the keyboard shortcut: C then F
- Select the contour sketch
- Cut some holes
- Select the planar face
- Select the hole layout sketch
- Press the Sketch On Sheet metal button
or use the keyboard shortcut: M then S
Done!
- Some hints
- Check if the folded object's thickness is built to the right side.
The yellow contour should lie on the top face of the bottom fold (as shown).
To reverse direction set the value of Bend Side property (Outside <-> Inside).
- Hole shapes not touching the used planar face won't cut holes into the folded object.
The lower rectangle which is hardly touching said face does cut a hole while the upper slot shape doesn't.
- Check if the folded object's thickness is built to the right side.