Jump to content

Editing Translations:Sketcher Micro Tutorial - Constraint Practices/23/ru

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Sketcher Micro Tutorial - Constraint Practices)
:3.2. Select one horizontal line, and press {{Button|[[File:Sketcher_ConstrainDistanceX.svg|16px]] [[Sketcher_ConstrainDistanceX|Horizontal Dimension]]}}, then enter {{Value|20 mm}}.
:3.3. Select the other horizontal line, and repeat the constraint with the same dimension.
:3.4. Select one vertical line, and press {{Button|[[File:Sketcher_ConstrainDistanceY.svg|16px]] [[Sketcher_ConstrainDistanceY|Vertical Dimension]]}}, then enter {{Value|20 mm}}.
:3.5. Select the other vertical line, and repeat the constraint with the same dimension.
:3.6. Select one bottom corner point (a), and the origin of the sketch, and press {{Button|[[File:Sketcher_ConstrainDistanceX.svg|16px]] [[Sketcher_ConstrainDistanceX|Horizontal Dimension]]}}, then enter {{Value|10 mm}}.
:3.7. Select the top corner point (b) above the previous corner point (a), and the origin of the sketch, and repeat the constraint with the same dimension.
:3.8. Select the other bottom corner point (c), and the origin of the sketch, and press {{Button|[[File:Sketcher_ConstrainDistanceY.svg|16px]] [[Sketcher_ConstrainDistanceY|Vertical Dimension]]}}, then enter {{Value|10 mm}}.
:3.9. Select the top corner point (b) again, and the origin of the sketch, and repeat the constraint with the same dimension.
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

Please note that all contributions to FreeCAD Documentation are considered to be released under the Creative Commons Attribution (see FreeCAD:Copyrights for details). If you do not want your writing to be edited mercilessly and redistributed at will, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource. Do not submit copyrighted work without permission!

Formatting help

Cancel Editing help (opens in new window)

Templates used on this page:

Retrieved from "http://wiki.freecad.org/Translations:Sketcher_Micro_Tutorial_-_Constraint_Practices/23/ru"