Jump to content

Editing Translations:SheetMetal AddWall/24/pl

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (SheetMetal AddWall)
# Create a blank
## Select the outline sketch </br> [[Image:SheetMetal_AddWall-03.png|240px]] 
## Press the {{Button|[[Image:SheetMetal_AddBase.svg|16px]] [[SheetMetal_AddBase|Make Base Wall]]}} button </br> or use the keyboard shortcut: {{KEY|C}} then {{KEY|F}} </br> [[Image:SheetMetal_AddWall-04.png|240px]] </br> (The blank is padded in z direction </br> </br>
# Add walls to the outline edges 
## Select the blank's '''outline edges''' </br> [[Image:SheetMetal_AddWall-05.png|240px]]
## Press the {{Button|[[Image:SheetMetal_AddWall.svg|16px]] [[SheetMetal_AddWall|Make Wall]]}} button </br> or use the keyboard shortcut: {{KEY|W}} </br> [[Image:SheetMetal_AddWall-06.png|240px]]
## If the fold is 90° down set the value of '''invert''' property to true to reverse the direction (and '''length''' to a lower value for smaller walls) </br> [[Image:SheetMetal_AddWall-01.png|240px]] </br> </br>
# Add some more walls
## Select the tray's '''upper outside edges'''  </br> [[Image:SheetMetal_AddWall-08.png|240px]]
## Press the {{Button|[[Image:SheetMetal_AddWall.svg|16px]] [[SheetMetal_AddWall|Make Wall]]}} button </br> or use the keyboard shortcut: {{KEY|W}}  </br> [[Image:SheetMetal_AddWall-09.png|240px]] </br>
## The walls are a bit too long (but nicely trimmed) and so the '''length''' property has to be set to a lower value </br> [[Image:SheetMetal_AddWall-10.png|240px]]
## If you like the folds swing outward set the '''invert''' value to true </br> [[Image:SheetMetal_AddWall-11.png|240px]]
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

Please note that all contributions to FreeCAD Documentation are considered to be released under the Creative Commons Attribution (see FreeCAD:Copyrights for details). If you do not want your writing to be edited mercilessly and redistributed at will, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource. Do not submit copyrighted work without permission!

Formatting help

Cancel Editing help (opens in new window)

Templates used on this page: