Jump to content

Editing Translations:Part Loft Technical Details/8/pl

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Part Loft Technical Details)
[[File:Loft Number of verts match.png|thumb|300px|Demonstration of Loft keeping the number of segments in profiles when they match. Note how 3 edges of the top square "collapse" into a small polygonal piece of the bottom profile.]]
In case numbers of segments in all profiles were not equal, slicing was done in Step 1, and the correspondence is trivial.
In case numbers of segments in all profiles were equal, existing segments are used (see the picture), and this is when the correspondence must be established.
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

Please note that all contributions to FreeCAD Documentation are considered to be released under the Creative Commons Attribution (see FreeCAD:Copyrights for details). If you do not want your writing to be edited mercilessly and redistributed at will, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource. Do not submit copyrighted work without permission!

Formatting help

Cancel Editing help (opens in new window)
Retrieved from "http://wiki.freecad.org/Translations:Part_Loft_Technical_Details/8/pl"