Editing Translations:PartDesign Pad/58/es

* Like all Part Design features, Pad creates a solid, thus the sketch must include a closed profile or it will fail with a ''Wire is not closed'' error.
* Sketches containing [[B-Splines|B-Splines]] often cannot be tapered properly. This is a limitation of the [[OpenCASCADE|OpenCASCADE]] kernel that FreeCAD uses.
* For larger angles tapering will fail if the end face would have fewer edges than the start face/sketch.
* The algorithm used for '''To First''' and '''To Last''' is:
** Create a line through the center of gravity of the sketch
** Find all faces of the support cut by this line
** Choose the face where the intersection point is nearest/furthest from the sketch
: This means that the face that is found might not always be what you expected. If you run into this problem, use the '''Up to face''' type instead, and pick the face you want.
: For the very special case of extrusion to a concave surface, where the sketch is larger than this surface, extrusion will fail. This is an unresolved bug.