Information about message (contribute ) This message has no documentation.
If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Arch Rebar ) # Switch to the [[Image:Workbench_BIM.svg|16px]] [[BIM_Workbench|BIM Workbench]] # Create a {{Button|[[Image:Arch_Structure.svg|16px]] [[Arch_Structure|Structure]]}} element. # Switch to the [[Image:Workbench_Sketcher.svg|16px]] [[Sketcher_Workbench|Sketcher Workbench]]. # Select one face of the structural element. # Press the {{Button|[[Image:Sketcher_NewSketch.svg|16px]] [[Sketcher_NewSketch|New Sketch]]}} button to start a new sketch on the selected face. # Draw the diagram of your bar. # Press the {{Button|[[Image:Sketcher_LeaveSketch.svg|16px]] [[Sketcher_LeaveSketch|Leave Sketch]]}} button to finish. # Switch back to the [[Image:Workbench_BIM.svg|16px]] [[BIM_Workbench|BIM Workbench]]. # Select the sketch you just drew. # Press the {{Button|[[Image:Arch_Rebar.svg|16px]] [[Arch_Rebar|Rebar]]}} button, or press {{KEY|R}} then {{KEY|B}} keys. # Adjust the desired properties (your rebar might not appear immediately, if some of the properties create an impossible situation, such as the bar diameter being 0, or the offset distances being bigger than the length of the structural element).
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you
log in or
create an account , your edits will be attributed to your username, along with other benefits.