Part Versatz

From FreeCAD Documentation
Revision as of 08:41, 16 June 2020 by Maker (talk | contribs) (Created page with "# Wähle das Objekt, von dem du den Versatz erstellen möchtest. # Drücke die {{KEY|16px '''3D Versatz'''}} Schaltfläche # Passe Abstand und Param...")

Diese Dokumentation ist noch nicht fertiggestellt. Bitte hilf mit und trage etwas zur Dokumentation bei.

Die Seite GuiBefehl Modell erklärt, wie Befehle dokumentiert werden sollten. Unter Category:UnfinishedDocu findest du weitere unvollständige Seiten wie diese (und unter Category:UnfinishedDocu/de unvollständige Übersetzungen). Siehe Category:Command Reference für sämtliche Befehle (und Category:UnfinishedDocu/de für vorhandene Übersetzungen).

Siehe WikiSeiten, um zu lernen, wie die Wiki-Seiten bearbeitet werden und FreeCAD Unterstützen, um andere Wege zu entdecken, wie du einen Beitrag leisten kannst.

Part Versatz

Menüeintrag
Part → 3D Versatz
Arbeitsbereich
Part
Standardtastenkürzel
Keiner
Eingeführt in Version
-
Siehe auch
Dicke, Part 2D Versatz

Beschreibung

Das Werkzeug Teil 3D Versatz erzeugt parallele Kopien einer ausgewählten Form in einem bestimmten Abstand von der Grundform, wodurch ein neues Objekt entsteht.

Verwendung

  1. Wähle das Objekt, von dem du den Versatz erstellen möchtest.
  2. Drücke die 3D Versatz Schaltfläche
  3. Passe Abstand und Parameter in Abhängigkeit vom Originalobjekt und der Gültigkeit der resultierenden Objekte an.

Beispiel

  • DatenOffset: Distance to offset the faces of the shape
  • DatenMode: Mode of creation . Skin creates a new shape around the source shape. Pipe ( todo ) . RectoVerso ( todo )
  • DatenJoin type: How the new corners are build up. Intersection gives sharp corners by linear extension of the edges. Arc and Tangent give rounded corners.
  1. Option ː Intersection ː Allows offsets pointing inwards to "overflood" the gap by intersecting the resulting shape until opposite faces are reached.
  2. Option ː Self Intersection ː ( todo )
  3. Option ː Fill Offset ː When the shape was 2 dimensional , the gap inbetween the 2 shapes gets filled. The fill is now a solid, hence the source shape is not a solid . Thus boolean operations may lead to strange results. (see example below) .


Object with small offset and rounded ( arc ) corners.


Same object with sharp ( intersection ) corners.

Same object with thick distance overfilling the front left gap and allowed intersections.

Arbitrary shape ( draft poly as wire ) with a 3D Offset ( ignores MODE param )

same shape with a 3D Offset as SKIN and filled offset

filled offset with 2 Cylinders creating boolean cuts. Cylinder A goes through the FILL whilst Cylinder B only goes thru the FILL and NOT through the source 2D shape.