Projekt Części: Przenieś ze starszej wersji

From FreeCAD Documentation
Revision as of 20:36, 19 June 2023 by Kaktus (talk | contribs) (Created page with "==Użycie==")

Projekt Części: Przenieś ze starszej wersji

Lokalizacja w menu
Projekt Części → Przenieś ze starszej wersji ...
Środowisko pracy
Projekt Części
Domyślny skrót
brak
Wprowadzono w wersji
0.17
Zobacz także
brak

Opis

Środowisko pracy Projekt Części w FreeCAD v0.17 wprowadza nowe narzędzia i elementy, które nie są rozpoznawane przez starsze wersje FreeCAD wersja 0.16 i poniżej. Dokumenty FreeCAD utworzone w starszych wersjach mogą być nadal otwierane i edytowane. Aby skorzystać z nowych funkcji, należy je zmigrować za pomocą funkcji z menu Projekt Części → Przenieś ze starszej wersji.

dostępne w wersji 0.17

Użycie

  1. Open a FreeCAD document that was created with FreeCAD version 0.16 and below
  2. Switch to the PartDesign workbench.
  3. Go to the Part DesignMigrate menu.
  4. If the migration works, a Part container will be created which will hold one or more Bodies, each hosting a chain of features.

Limitations

  • Before starting the migration process, check if the model was built with automatic refine options enabled (in Edit → Preferences → Part design → General), and set your preferences accordingly. This can be easily determined by successively toggling the visibility of the features in the Model tree. If no residual edges are left between features such as Pads and Pockets, the automatic refine options were disabled.
  • If a document to migrate only contains sketches and PartDesign features, the migration process may likely succeed. Some features such as chamfers and fillets may require rebuilding.
  • If the document to migrate has a mixed Part/Part Design/Draft workflow, the conversion will most likely fail or at best produce unexpected results, and will need to be migrated manually.