PartDesign Migrate/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "==Opis==")
(Created page with "Środowisko pracy Projekt Części w FreeCAD v0.17 wprowadza nowe narzędzia i elementy, które nie są rozpoznawane przez starsze wersje FreeCAD {{VersionMinus/pl|0.16}}. Dokumenty FreeCAD utworzone w starszych wersjach mogą być nadal otwierane i edytowane. Aby skorzystać z nowych funkcji, należy je zmigrować za pomocą funkcji z menu {{MenuCommand|Projekt Części → Przenieś ze starszej wersji}}.")
Line 20: Line 20:
==Opis==
==Opis==


Środowisko pracy Projekt Części w FreeCAD v0.17 wprowadza nowe narzędzia i elementy, które nie są rozpoznawane przez starsze wersje FreeCAD {{VersionMinus/pl|0.16}}. Dokumenty FreeCAD utworzone w starszych wersjach mogą być nadal otwierane i edytowane. Aby skorzystać z nowych funkcji, należy je zmigrować za pomocą funkcji z menu {{MenuCommand|Projekt Części → Przenieś ze starszej wersji}}.
The PartDesign workbench in FreeCAD v0.17 introduces new tools and elements that are not recognized by older FreeCAD versions (0.16 and older). FreeCAD documents created in older versions can still be opened and edited. To benefit from the new features, they must be migrated via the menu PartDesign → Migrate.


{{Version|0.17}}
{{Version|0.17}}

Revision as of 20:36, 19 June 2023

Projekt Części: Przenieś ze starszej wersji

Lokalizacja w menu
Projekt Części → Przenieś ze starszej wersji ...
Środowisko pracy
Projekt Części
Domyślny skrót
brak
Wprowadzono w wersji
0.17
Zobacz także
brak

Opis

Środowisko pracy Projekt Części w FreeCAD v0.17 wprowadza nowe narzędzia i elementy, które nie są rozpoznawane przez starsze wersje FreeCAD wersja 0.16 i poniżej. Dokumenty FreeCAD utworzone w starszych wersjach mogą być nadal otwierane i edytowane. Aby skorzystać z nowych funkcji, należy je zmigrować za pomocą funkcji z menu Projekt Części → Przenieś ze starszej wersji.

introduced in version 0.17

Usage

  1. Open a FreeCAD document that was created with FreeCAD version 0.16 and below
  2. Switch to the PartDesign workbench.
  3. Go to the Part DesignMigrate menu.
  4. If the migration works, a Part container will be created which will hold one or more Bodies, each hosting a chain of features.

Limitations

  • Before starting the migration process, check if the model was built with automatic refine options enabled (in Edit → Preferences → Part design → General), and set your preferences accordingly. This can be easily determined by successively toggling the visibility of the features in the Model tree. If no residual edges are left between features such as Pads and Pockets, the automatic refine options were disabled.
  • If a document to migrate only contains sketches and PartDesign features, the migration process may likely succeed. Some features such as chamfers and fillets may require rebuilding.
  • If the document to migrate has a mixed Part/Part Design/Draft workflow, the conversion will most likely fail or at best produce unexpected results, and will need to be migrated manually.