FEM ResultShow/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "Okno dialogowe jest zaprezentowane po lewej i posiada następujące cechyː")
No edit summary
Line 39: Line 39:
[[File:FEM_Result-Object-Dialog.png|left|framed]]
[[File:FEM_Result-Object-Dialog.png|left|framed]]


Okno dialogowe jest zaprezentowane po lewej i posiada następujące cechyː
Okno dialogowe jest zaprezentowane po lewej i oferuje następujące możliwośćː


* Select a result type and the minimum and maximum will be displayed in the dialog. The result mesh will be colored accordingly.
* Select a result type and the minimum and maximum will be displayed in the dialog. The result mesh will be colored accordingly.

Revision as of 19:26, 22 November 2023

Pokaż wyniki

Lokalizacja w menu
Wyniki → Pokaż wyniki
Środowisko pracy
MES
Domyślny skrót
R S
Wprowadzono w wersji
-
Zobacz także
Prezentacja graficzna wyników, Poradnik MES

Opis

To polecenie otwiera okno dialogowe dla obiektu wyników MES. Obiekt wyników jest automatycznie tworzony gdy analiza MES jest przeprowadzana przy użyciu solvera Calculix lub Z88.

Obiekt wyników zawiera siatkę wynikową i pozwala na wizualizację wyników. Jest stworzony, a więc i ograniczony do wyników termomechanicznych. Oprócz solvera Elmer, może być używany jako alternatywa dla prezentacji graficznej wyników. Prezentacja graficzna wyników może być używana do wyświetlania dowolnego typu wyników (również elektrycznych itd.).

Jednostki używane przez obiekt wyników to te ustawione w systemie jednostek, podczas gdy dla prezentacji graficznej wyników są to jednostki SI.

Wizualizacja wyników jest aktywna tylko gdy okno dialogowe jest otwarte. Jednak ustawienia okna dialogowego są przechowywane w pliku z modelem FreeCAD.

Użycie

Aby pokazać okno dialogowe wyników, zaznacz obiekt wyników w widoku drzewa a następnie wciśnij przycisk Pokaż wyniki lub wybierz opcję Wyniki → Pokaż wyniki (skrót R a następnie S) z menu. Alternatywnie, możesz również kliknąć dwukrotnie na obiekcie wyników w widoku drzewa.

Gdy okno dialogowe jest otwarte, siatka wynikowa jest automatycznie pokazana.

Okno dialogowe jest zaprezentowane po lewej i oferuje następujące możliwośćː

  • Select a result type and the minimum and maximum will be displayed in the dialog. The result mesh will be colored accordingly.
  • Click on the button Histogram to get a histogram what amount of result mesh nodes have a certain result. The histogram plot can be modified by the buttons in its toolbar. it is also possible to save the histogram as image using the save button from its toolbar.
  • Check the option Show to enables the slider and to visualize the result mesh deformation. The slider value is a factor with which the result Displacement Magnitude is multiplied.
    Note: The slider only affects the Displacement Magnitude, not its X, Y, Z components.
  • With the button Calculate you can perform calculations of the results. Input in the text box below the button an equation of you choice. Predefined is the equation P1-P3. This means the result Min Principal Stress is subtracted from the Max Principal Stress. The variables for the possible results are explained in the box User defined equation.
    After you input an equation press the button and the result will be shown in the fields displaying the minimum and maximum. The result mesh will be colored accordingly.
    Note: The calculation results always have the unit MPa, mm or T, no matter what unit system you use.