All translations

Enter a message name below to show all available translations.

Message

Found 7 translations.

NameCurrent message text
 h Deutsch (de)Der Befehl [[Image:Part_Tube.svg|24px]] '''Part Rohr''' erstellt einen parametrischen Volumenkörper, ein Rohr (Hohlzylinder). Im Koordinatensystem durch seine {{PropertyData/de|Placement}} festgelegt, liegt die Unterseite des Rohrs auf der XY-Ebene mit ihrem Mittelpunkt im Ursprung.
 h English (en)The [[Image:Part_Tube.svg|24px]] '''Part Tube''' command creates a parametric tube solid. In the coordinate system defined by its {{PropertyData|Placement}} property, the bottom face of the tube lies on the XY plane with its center at the origin.
 h español (es)El comando Tubo inserta un tubo en el documento activo. El tubo es geométricamente tratado como un corte de un cilindro más pequeño dentro de otro mayor. Por defecto, el comando insertará un tubo de 10 mm de altura con un radio exterior de 5 mm y un radio interior de 2 mm. Estos parámetros pueden ser modificados tras ser introducido el objeto.
 h français (fr)La commande [[Image:Part_Tube.svg|24px]] '''Part Tube''' crée un solide tubulaire paramétrique. Dans le système de coordonnées défini par sa propriété {{PropertyData|Placement}}, la face inférieure du tube se trouve sur le plan XY avec son centre à l'origine.
 h italiano (it)Il comando [[Image:Part_Tube.svg|24px]] '''Part Tubo''' crea un  tubo parametrico solido. Nel sistema di coordinate definito dalla sua proprietà {{PropertyData|Placement}}, la faccia inferiore del tubo si trova sul piano XY con il centro nell'origine.
 h polski (pl)Polecenie [[Image:Part_Tube.svg|24px]] '''Rura''' środowiska pracy Część tworzy parametryczną bryłę rury. W układzie współrzędnych zdefiniowanym przez właściwość {{PropertyData|Umiejscowienie}} dolna ściana stożka leży na płaszczyźnie XY, a jej środek jest w punkcie początkowym.
 h русский (ru)Команда Создать Трубу вставляет трубку в активный документ. Труба геометрически рассматривается как вырез меньшего цилиндра из большего. По умолчанию команда создаст трубку высотой 10 мм с наружным радиусом 5 мм и внутренним радиусом 2 мм. Эти параметры могут быть изменены после добавления объекта.