All translations

Enter a message name below to show all available translations.

Message

Found 2 translations.

NameCurrent message text
 h English (en)* Depending on the size and complexity of the area for the operation, is might be better to not recompute the operation after every property change; rather, consider:
** deactivate the operation with the {{KEY|[[Image:CAM_OpActiveToggle.svg|16px]] [[CAM_OpActiveToggle|Active]]}} toggle tool, make your changes to the operation's properties, then click the {{KEY|[[Image:CAM_OpActiveToggle.svg|16px]] [[CAM_OpActiveToggle|Active]]}} icon again to re-activate the operation - which triggers a recompute internally.
* The {{KEY|[[Image:CAM_Adaptive.svg|16px]] [[CAM_Adaptive|Adaptive]]}} operation might contain a few bugs yet to be clearly identified. Please report bugs and issues in the [https://forum.freecadweb.org/viewforum.php?f=15 FreeCAD Path/CAM Forum].
* All tool shapes may not be respected with this operation. Check the FreeCAD forum for further details. 
* Should you choose to run the path simulator in the CAM Workbench, it only uses the standard end mill to simulate paths. Therefore, you will not see tool-shape-specific material removal. Material removal is shown using the end mill shape.
 h français (fr)* En fonction de la taille et de la complexité de la zone pour l'opération, il peut être préférable de ne pas recalculer l'opération après chaque changement de propriété. Considérez plutôt :
** Désactivez l'opération avec l'outil {{KEY|[[Image:CAM_OpActiveToggle.svg|16px]] [[CAM_OpActiveToggle/fr|Activer une opération]]}}, apportez vos modifications aux propriétés de l'opération puis cliquez sur le {{KEY|[[Image:CAM_OpActiveToggle.svg|16px]] [[CAM_OpActiveToggle/fr|Activer une opération]]}} à nouveau pour réactiver l'opération, ce qui déclenche un recalcul en interne.
* L'opération {{KEY|[[Image:CAM_Adaptive.svg|16px]] [[CAM_Adaptive/fr|Activer une opération]]}} peut contenir quelques bogues non encore clairement identifiés. Veuillez signaler les bogues et les problèmes sur le [https://forum.freecadweb.org/viewforum.php?f=15 FreeCAD CAM/CAM Forum].
* Toutes les formes d'outils peuvent ne pas être respectées avec cette opération. Consultez le forum FreeCAD pour plus de détails.
* Si vous choisissez d'exécuter le simulateur de parcours dans l'atelier CAM, il utilise uniquement la fraise de bout standard pour simuler des parcours. Par conséquent, vous ne verrez pas l’enlèvement de matière spécifique à une forme d’outil. L'enlèvement de matière est illustré à l'aide de la forme de la fraise.