Croquizador RestringirPerpendicular

From FreeCAD Documentation
Revision as of 22:15, 21 December 2013 by Renatorivo (talk | contribs) (Created page with "====Descripción==== La restricción perpendicular fuerza a las dos líneas seleccionadas en el croquis a ser perpendiculares entre si.")

Constraint Perpendicular

Ubicación en el Menú
Croquizador → Restricciones del Croquizador → Perpendicular
Entornos de trabajo
Croquizador, Diseño de Piezas
Atajo de teclado por defecto
N
Introducido en versión
-
Ver también
Ángulo

Descripción

La restricción perpendicular fuerza a las dos líneas seleccionadas en el croquis a ser perpendiculares entre si.

Operation

The sketch below has two lines at a random angle.



Select the two line segments you require to be perpendicular



then click the Constrain Perpendicular icon in the Sketcher toolbar or select the Constrain Perpendicular menu item from the Sketcher constraints sub menu of the Sketcher or Part Design menus (depending upon whether the Sketcher or Part Design workbench is selected) to apply the constraint to the selected lines.



The lines are constrained to be perpendicular.