Projekt Części: Przenieś ze starszej wersji

From FreeCAD Documentation
Revision as of 20:40, 19 June 2023 by Kaktus (talk | contribs) (Created page with "==Ograniczenia==")

Projekt Części: Przenieś ze starszej wersji

Lokalizacja w menu
Projekt Części → Przenieś ze starszej wersji ...
Środowisko pracy
Projekt Części
Domyślny skrót
brak
Wprowadzono w wersji
0.17
Zobacz także
brak

Opis

Środowisko pracy Projekt Części w FreeCAD v0.17 wprowadza nowe narzędzia i elementy, które nie są rozpoznawane przez starsze wersje FreeCAD wersja 0.16 i poniżej. Dokumenty FreeCAD utworzone w starszych wersjach mogą być nadal otwierane i edytowane. Aby skorzystać z nowych funkcji, należy je zmigrować za pomocą funkcji z menu Projekt Części → Przenieś ze starszej wersji.

dostępne w wersji 0.17

Użycie

  1. Otwórz dokument FreeCAD, który został utworzony za pomocą FreeCAD wersja 0.16 i poniżej.
  2. Przełącz się na środowisko pracy Projekt Części.
  3. Przejdź do menu Projekt Części → Przenieś ze starszej wersji.
  4. Jeśli migracja się powiedzie, zostanie utworzony obiekt kontener, który będzie zawierał jedną lub więcej Zawartości, z których każda będzie zawierała łańcuch cech.

Ograniczenia

  • Before starting the migration process, check if the model was built with automatic refine options enabled (in Edit → Preferences → Part design → General), and set your preferences accordingly. This can be easily determined by successively toggling the visibility of the features in the Model tree. If no residual edges are left between features such as Pads and Pockets, the automatic refine options were disabled.
  • If a document to migrate only contains sketches and PartDesign features, the migration process may likely succeed. Some features such as chamfers and fillets may require rebuilding.
  • If the document to migrate has a mixed Part/Part Design/Draft workflow, the conversion will most likely fail or at best produce unexpected results, and will need to be migrated manually.