PartDesign: Elipsoid Substractiv

From FreeCAD Documentation
Revision as of 19:41, 1 November 2018 by Luc (talk | contribs)

PartDesign SubtractiveEllipsoid

Menu location
Part Design → Create an subtractive primitive → Subtractive Ellipsoid
Workbenches
PartDesign
Default shortcut
None
Introduced in version
-
See also
PartDesign CompPrimitiveSubtractive

Descriere

Inserează un elipsoid substractiv în corpul activ. Forma lui este extrasă din solidul existent.

introduced in version 0.17

În partea stângă: corpul activ (A) afișat în gri și elipsoidul substractiv (B) afișat în roșu transparent; rezultatul în partea dreaptă.

Cum se folosește

  1. Apăsați mai întâi butonul Subtractive Ellipsoid . Notă: Elipsoidul Subtractiv face parte dintr-un meniu cu pictograme etichetat Create an additive primitive. După lansarea FreeCAD, Subtractiv Elipsoid este printe cele afișate în toolbar. Pentru a obține butonul Ellipsoid, click pe săgeata în jos alături de iconița vizibilă și selectați Ellipsoid in meniu.
  2. Definiți parametrii Primitivei geometrice și Attachment.
  3. Click pe OK.
  4. O funcție(onalitate) Ellipsoid apare sub Copul activ.

Opţiuni

The Ellipsoid can be edited after its creation in two ways:

  • Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
  • Via the Property editor.

Proprietăți

  • DateAttachment: defines the attachment mode as well as the Attachment Offset. See Part Attachment.
  • DateLabel: label given to the Ellipsoid object. Change to suit your needs.
  • DateRadius1: the radius value along the ellipsoid's vertical axis; by default, parallel to the Z-axis.
  • DateRadius2: the radius value along the ellipsoid's length; by default, parallel to the X-axis.
  • DateRadius2: the radius value along the ellipsoid's width; by default, parallel to the Y-axis. At the default value of zero, the ellipsoid forms an oblate spheroid.
  • DateAngle1: (labelled V parameter in the Primitive parameters) lower truncation of the ellipsoid, parallel to the circular cross section (-90 degrees in a full spheroid)
  • DateAngle2: (unlabelled in the Primitive parameters) upper truncation of the ellipsoid, parallel to the circular cross section (90 degrees in a full spheroid).
  • DateAngle3: (labelled U parameter in the Primitive parameters) angle of rotation of the elliptical cross section (360 degrees in a full spheroid).