SheetMetal Exemples

From FreeCAD Documentation
Revision as of 21:31, 24 September 2021 by David69 (talk | contribs) (Created page with "Pour éviter de surcharger les pages d'outils avec des exemples, cette page a été ajoutée pour rassembler les pièces montrant et expliquant les caractéristiques spéciale...")

Cette documentation n'est pas terminée. Merci de nous aider et de contribuer à la documentation.

Modèle GuiCommand explique comment les commandes doivent être documentées. Parcourez Category:UnfinishedDocu pour voir d'autres pages incomplètes comme celle-ci. Voir Category:Command_Reference pour toutes les commandes.

Voir Écrire une page Wiki pour apprendre à éditer les pages du wiki, et aller à Contribuer à FreeCAD pour apprendre d'autres façons de contribuer.
Other languages:

Introduction

L'atelier SheetMetal est devenu très puissant et exige une documentation appropriée.

Pour éviter de surcharger les pages d'outils avec des exemples, cette page a été ajoutée pour rassembler les pièces montrant et expliquant les caractéristiques spéciales de SheetMetal.

Planned phases to generate content:

  1. Collecting pictures
  2. Adding workflow descriptions
  3. Adding more detailed tutorials

Hinge



Workflow Hinge: Make Base Wall, PartDesign Pocket, PartDesign Hole, Unfold.

Paper Clip



Workflow Paper Clip: Make Base Wall, Sketch on Sheet, clone, flip and fuse, Unfold.

Too bad that there is a tool missing to mirror the whole object.
A link object could be mirrored, but when fused (boolean) unfold will fail.
To achieve an unfoldable part with both halves fused a clone or one of a pair of link objects has to be flipped (turned by 180°) instead of being mirrored.

Omega Clamp



Workflow Omega Clip: Make Base Wall, PartDesign Hole, PartDesign Fillet, Unfold.

Hex Bowl



Workflow Hex Bowl: Make Base Wall, Make Wall, 6x Add Corner Relief, Unfold.

When a Corner Relief is added (right side) it can be necessary to adjust the value of the Size property.

Pen Clip



Workflow Pen Clip: Make Base Wall, PartDesign Pocket, 3x Make Wall, Unfold.

Extend Face Example



Workflow Extend Face Example: Make Base Wall, Make Wall, Extend Face, Extend Face, Unfold.

For the second use of Extend Face a Sketch with two contours is used for shape of the extension(s); and with the value of "use subtraction" set to true it provides the shape for the cut-outs, as well

USB shield contact



Workflow USB shield contact: Make Base Wall, Extend Face, PartDesign Pocket, Extend Face, Make Wall, Unfold.

(The pull relief is just an artistic expression of what could be hidden inside a real plug)