FCGear: Puleggia per cinghia dentata

From FreeCAD Documentation
Revision as of 15:34, 28 May 2024 by Simone.b (talk | contribs) (Created page with "Un oggetto FCGear TimingGear deriva da un oggetto Part Feature ed eredita tutte le sue proprietà. Ha inoltre le seguenti proprietà aggiuntive:")
Other languages:

Puleggia per cinghia dentata

Posizione nel menu
Gear → Timing Gear
Ambiente
FCGear
Avvio veloce
None
Introdotto nella versione
v0.16
Vedere anche
Nessuno

Descrizione

Lo scopo degli ingranaggi di distribuzione è quello di consentire all'albero a camme e all'albero motore di far ruotare la catena di distribuzione. L'albero motore gira per muovere i pistoni su e giù all'interno dei cilindri. L'albero a camme ruota per consentire l'apertura e la chiusura delle valvole di aspirazione e di scarico sui cilindri. Questi componenti sono importanti per la corretta sincronizzazione del motore.

Gli ingranaggi di distribuzione sono collegati a una cinghia o catena di distribuzione.

Sopra: puleggia per cinghia dentata

Utilizzo

  1. Passare a FCGear.
  2. Esistono diversi modi per richiamare il comando:
    • Premere il pulsante Timing Gear nella barra degli strumenti.
    • Selezionare l'opzione Gear → Timing Gear dal menu.
  3. Modificare il parametro dell'ingranaggio alle condizioni richieste (vedere Proprietà).

Proprietà

Un oggetto FCGear TimingGear deriva da un oggetto Part Feature ed eredita tutte le sue proprietà. Ha inoltre le seguenti proprietà aggiuntive:

Dati

base

  • Datiheight (Length): Default is 5 mm. Value of the gear width.
  • Datiteeth (Integer): Default is 15. Number of teeth.
  • Datitype (Enumeration): Default is gt2. Type of timing gear – profile pitch for timing belts (see Notes).

computed

  • Datih (Length): (read-only) Radial height of teeth.
  • Datioffset (Length): (read-only) X-Offset of second arc mid-point.
  • Datipitch (Length): (read-only) Pitch of gear.
  • Datir0 (Length): (read-only) Radius of first arc.
  • Datir1 (Length): (read-only) Radius of second arc.
  • Datirs (Length): (read-only) Radius of third arc.
  • Datiu (Length): (read-only) Radial difference between pitch … diameter and head of gear.

version

  • Dativersion (String):

Note

  • type: The pitch of the timing belts (distance from tooth centre to tooth centre of consecutive teeth) is specified in types. GT2 has a pitch of 2 mm, GT3 of 3 mm, GT5 of 5 mm etc..

Formule utili

  • addendum diameter = pitch diameter + 2 * module
  • belt length = 2 * axle base + belt tooth pitch : 2 * (teeth 1 + 2) + belt tooth pitch² : 4 * pi² * axle base * (teeth 1 - 2)²
  • axle base = belt length : 4 - belt tooth pitch : 8 * (teeth 1+2) + ¼ * sqrt [belt length - ½ * belt tooth pitch * (teeth 1+2)² - 2 * belt tooth pitch² * (teeth 1+2)² : pi²]